1. Acquired Ph.D. (Engg) degree from Jadavpur University, Kolkata, in 2013.
2. Obtained M.Tech. Degree in Production Technology from Jadavpur University, Kolkata in 2006.
3. Obtained B.Tech degree in Production Engineering from Jadavpur University, Kolkata in 2004.
1. Current post: Assistant Professor in Dept. of Mechanical Engg., Aliah University, Kolkata, India, since November 11, 2010.
2. Worked as a Assistant Professor in Dept. of Production Engg., Haldia Institute of Technology, West Bengal, India, July 2010 to November 10, 2010.
3. Worked as a Senior Research Fellow (under State Govt. Departmental Fellowship) at Jadavpur University,Kolkata, India, September 2006- July 2010.
Conference Papers Published
List of publication and presentation in international conference:
- ‘Determination of optimal WEDM cutting condition of Inconel 718’, Proceedings of the Fifth International Conference on Precision, Meso, Micro and Nano Engineering, 2007,College of Engineering, Trivandrum, India, December 13-14, pp.295-299.
- ‘Experimental Investigation on Machining Parameter Optimization in Wire Electrical Discharge Machining of Varying Height Job’, Proceedings of the Sixth International Conference onPrecision, Meso, Micro and Nano Engineering, 2009, 11-12 December, pp.G24-27.
- ‘Optimization of Wire Electrical Discharge Machining Process Parameters using Taguchi and Grey Relational Analysis Method’,Proceedings of 3rd International and 24th AIMTDR conference, 2010, December 11-12, College of Engineering (A), Andhra University, Visakhapatnam-530003, pp.189-192.
- ‘Development of an Empirical Method to Measure the Wire Lag in WEDM’, Proceedings of the Seventh International Conference on Precision, Meso, Micro and Nano Engineering, 2011,December 10-11, pp.224-228.
List of publication and presentation in national conference:
- ‘Multiobjective Optimization of Wire Electrical Discharge Machining based on Grey Relational Analysis Method’, Proceedings of the RAMTM-2010, February, 19-20, Production Engineering Department, Jadavpur University, pp.99-103.
Journal Papers Published
International Referred Journal:
- ‘Modeling and optimization of wire electrical discharge machining of γ-TiAl in trim cutting operation’, Journal of Materials Processing Technology, Vol 205 (2008), pp 376-387.
- ‘A novel method of determination of wire lag for enhanced profile accuracy in WEDM, Precision Engineering, Vol. 35 (2011), pp.339–347.
- ‘Influence of different control strategies in wire electrical discharge machining of varying height job’, Int J Adv Manuf Technol (2016). doi:10.1007/s00170-016-9045-y.